You mean only water and nothing else? In this TEK I found here on
bbgate is used ethanol water solution and vodka as solvent:
https://bbgate.com/threads/tutorial-how-to-lay-lsd-blotters-lsd-sheets.8205/
He mentions in the tek: ...high ethanol content is bad. Firstly, LSD really does not want to dissolve in ethanol, this is why you need to have some % of H2O in your solution. ...
In this example, we will be using Grey Goose vodka as our solvent, with an Ethanol:H2O ratio of 4:6. People do usually go for a higher ethanol:H2O ratio. This is mainly to speed up the drying process, since ethanol evaporates a lot faster than H2O.
I also got this reply from Acidosis: iseeghostsSimply dissolve your crystals in a mixture of methanol and biodistilled water in the proportion of 70/30, for each gram of LSD you can calculate the potency of each drop taking into account that 1ml is 35-40 drops depending on each dropper. To be able to prepare your blotter, the trick is to purchase your blotterart on any available blotterart page and once you have everything prepared, make an etxa bed of nails or thumbtacks and place your sheet on top and with a syringe disperse drop by drop on each blotter. dissolution of lsd. Normally the sheets are usually 500 squares, place the sheet on your bed of nails and if you want to put 100mcg in each one, you must dissolve 50mg of crystal in 20ml of alcohol/water and dissolve your LSD well in the mixture, put it inside a geringilla and distribute evenly on the sheet, one drop for each marked square and thus you will obtain a good uniform distribution in your blotterart.
So which way should I do it? I probably want to first try it with smaller amount but then I will be doing it in bulk.